Acer ARMC Instrukcja Użytkownika Pobierz pdf (Strona 13)

Chapter Two : Installing Your ARMC Card

Chapter 2 Installing Your ARMC Card

Before You Start

Avoid Electro-Static Discharge (ESD)

Electro-Static Discharge (ESD) can damage the ARMC card and other system

components. Keep your ARMC card in its anti-static bag until it is to be installed.

Avoid contact with any component or connector on any adapter card, printed circuit

board, or memory module. Handle these components by the mounting bracket.

Perform all unpacking and installation procedures on a ground-connected anti-static mat.

Wear an anti-static wristband grounded at the same point as the anti-static mat. You can

also use a sheet of conductive aluminum foil grounded through a one megaohm resistor

instead of the anti-static mat. Similarly, a strip of conductive aluminum foil wrapped

around the wrist and grounded through a one megaohm resistor serves the same purpose

as a wristband.

ARMC Installation and Setup

Use the following steps to install the ARMC card into the host system.

Step Action

1 Unpack the ARMC card (and check jumper settings)

2 Install the optional battery and battery clip

3 Install the optional modem daughterboard

4 Plug in the ARMC card into the host system and attach internal cables

5 Connect external cables

6 Confirm the motherboard’s BIOS settings

7 Install the operating system and ARMC card’s display adapter drivers

8 Install all Acer-ARMC Windows Host Components

9 Setup your client system’s Internet browser

10 Connect to the ARMC from a client system

11 Load the ARMC SDK file for your model

Note: Inspect the cardboard carton for obvious damage.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 172 173

Brak uwag

Acer ARMC Instrukcja Użytkownika Strona 13